What are the adjustment methods of cutting machine pressure

1, adjustable two claw block and gear disc orientation, the claw block upward movement, pressure increase shear claw block of each action of a tooth, the distance between the two surfaces change the amount of about 0.1 mm, usually adopt the action of only one tooth.


2, when the claw block in the tooth plate bearing to the end of a tooth, you should consider a new gear and bias bias. The following methods can be used to adjust: loosen the screws to loosen the gear bias adjustment plate, and the gear wrench to adjust the back gear bias.


Then note that the number of teeth should be rotated equally, no more than three teeth. Equipment tooth adjustment plate, screw, claw block will be adjusted to the first tooth, look for shear pressure effect, the effect is not satisfactory, you can make adjustments, should pay attention to the tooth of the rotation of the gear, should be smaller than the tooth of the first rotation.


This method can also be used when the pressure on the left or right side is too low, that is, the small pressure adjusts which side and which side of the gear hurts, and tries to cut the claw block and return the 1-2 teeth properly.


3. When the upper and lower pressure is applied, the release pad and the hook type fastening plate adjustment screw block and the gasket with the hook type pad to increase the thickness are used together to reduce the plate thickness in the cavity block, and the operating surface unit is used in the face of increasing pressure; Conversely, low pressure.